UNIVERGE SV8100
System Hardware Manual
8.4.2
Wall Mounting the Bluetooth Cradle
To prevent possible damage to the BCH-L (BK)
UNIT due to falling, NEC recommends installing
the unit in a firm position so it cannot fall because
of its own weight.
Clearances required for installing the Bluetooth cradle are shown
below. Avoid mounting the cradle on a plaster-board wall, but before
mounting the cradle on a wall, check that the wall can support the
weight of the telephone and withstand the load from pulling the
telephone during operation.
Figure 6-77 Wall Mount Spacing Guide BCH-L (BK) UNIT
1.
Attach two wood screws to the wall.
Keep a clearance of about 0.08" (2mm) between each wood screw
and the wall (refer to
6-64).
Figure 6-78 Installing Wood Screws on page
Issue 2.0
6 - 63