NEC Univerge SV8100 System Hardware Manual page 278

Issue 2.0
4 - 28
Each node in a NetLink network requires the

PZ-ME50-US.
CD-CP00-US without the PZ-ME50-US

installed, supports a single chassis system (six
slots only).
CD-CP00-US with the PZ-ME50-US is required

to support a system with multiple chassis.
CD-CP00-US without the PZ-ME50-US

supports only (one) CD-LTA (8 Digital Station/
2SLT) blade.
Failure to properly install and program ports

higher than 64 (as described below) can corrupt
the SV8100 database.
When the PZ-ME50-US is not physically
installed on the CD-CP00-US, do not attempt to
change the PCPro database configuration to
indicate that the PZ-ME50-US is installed on the
CD-CP00-US, Program ports 64 and higher, and
then upload the PCPro configuration to the
SV8100 system. This process can cause the
SV8100 database to be corrupted. Refer to the
next bullet for the proper installation/
programming procedure.
To properly install and configure the

PZ-ME50-US; first install the PZ-ME50-US on
the CD-CP00-US. To program the ports above
64 using PCPro, perform a new download before
attempting to program the ports.
If the PZ-ME50-US is installed on the CPU at a

later date, a system upgrade must be performed
using the CD-CP00-US upgrade procedures.
When a PZ-ME50-US is mounted on a CPU, all
software upgrades are stored on this daughter
board. If the PZ-ME50-US were to be removed
from the CPU, a software upgrade must be
performed to bring the CPU to the latest version.
UNIVERGE SV8100
Installing the SV8100 Blades