Mitsubishi Electric Melsec QJ71LP21 Reference Manual page 266

7 APPLICATION FUNCTIONS
Control data
Device Item
Error completion
(S1)+0
type
(S1)+1 Completion status
(S1)+2 Host station channel
Channel used by
(S1)+3
sending station
Network No. of
(S1)+4
sending station
(S1)+5 Sending station No.
(S1)+6 (Use prohibited)
(S1)+7 (Use prohibited)
Arrival monitoring
(S1)+8
time
(S1)+9 Receive data length
(S1)+10 (Use prohibited)
(S1)+11 Clock set flag
(S1)+12
Clock data on error
to
completion
(S1)+15
2: The setting side is as shown below.
User : It is data the user sets in the sequence program before execution of a link dedicated instruction.
System: The programmable controller CPU stores the execution result of the link dedicated instruction.
7 - 42
b15 to
to
0
1) Error completion type (bit 7)
Specify the clock data setup status for error completion.
0: Clock data at the time of error completion is not set in the area starting from (S1)+11.
1: Clock data at the time of error completion is set in the area starting from (S1)+11.
The instruction completion status is stored.
0 : Normal
Other than 0 : Error (Refer to Section 8.3 for error codes)
Specify the channel of the host station, where receive data are stored.
1 to 8: Channel
Stores the channel used by the sending station.
1 to 8: Channel
Stores network No. of the sending station.
1 to 239: Network No.
Stores station No. of the sending station.
1 to 64: Station No.
Specify the monitoring time required for instruction completion.
If not completed within the time, the instruction is terminated with an error.
0 : 10 seconds
1 to 32767 : 1 to 32767 seconds
Stores the receive data size stored in (D1) to (D1)+ n.
1 to 960: Number of received data (words)
The valid or invalid status of the data in the area starting from (S1)+12 is stored.
(Data are stored when "1: Clock data at the time of error completion is set in the area starting
from (S1)+11." is set in the error completion type in (S1)+0).
Note that the stored value will not be cleared even after the dedicated instruction is
completed.
0: Invalid
1: Valid
Clock data on error completion are stored in BCD format.
(Data are stored when "1: Clock data at the time of error completion is set in the area starting
from (S1)+11." is set in the error completion type in (S1)+0).
Note that the stored value will not be cleared even after the dedicated instruction is
completed.
b15
(S1) 12
Month (01
Hour (00
(S1) 13
(S1) 14 Second (00
(S1) 15 Year (00 to 99
H
Setting data
b8 b7 b6 to
1) to
0 0
to
b8 b7
to 12 ) Year (00 to 99
H H
H
to 23 ) Date (01
H H
Minute (00
to 59 )
H H
), First 2 digits Day of the week (00
H
00 (Sun.) to 06
H
Setting range
b0
0
0000
0080
0 to 32767
to
b0
), Last 2 digits
H
to 31 )
H H
to 59 )
H H
to 06 )
H H
(Sat.)
H
(Continued to the next page)
MELSEC-Q
Setting
side 2
H
User
H
System
1 to 8 User
System
System
System
User
System
System
System
7 - 42