Mitsubishi Electric Melsec QJ71LP21 Reference Manual page 265

7 APPLICATION FUNCTIONS
Applicable device
Setting
Internal device
data
Bit Word
(S1)
(D1)
(D2)
Instruction format
[Network No. specification]
[Instruction symbol]
JP.RECV
[Network module start I/O No. specification]
[Instruction symbol]
GP.RECV
Setting data
Setting data 1
Network No. of the host station (1 to 239, 254)
Jn
254: The network specified in Valid module during other station access
Start I/O number of the host station's network module
Un
(00 to FE
H
(S1) Start device of the host station that stores control data
Start device of the host station that stores receive data
(D1)
(A contiguous area for the receive data length is required.)
The host station's device that is turned on for one scan upon completion of the
(D2) instruction
(D2)+1 also turns on if the instruction execution has failed.
1: Local devices and file registers for each program cannot be used as devices in setting data.
2: The setting side is as shown below.
User : It is data the user sets in the sequence program before execution of a link dedicated instruction.
System: The programmable controller CPU stores the execution result of the link dedicated instruction.
7 - 41
2) JP/GP.RECV
This instruction is used when sending data from the network module in
another station.
Link direct device
File register
Bit
[Execution condition]
[Execution condition]
Description
: The higher two digits of the 3-digit I/O number)
Applicable device
Intelligent function
J \ module device
Word U \G
Command
JP.RECV
Command
GP.RECV
Index register
Zn
Jn (S1) (D1) (D2)
Un (S1) (D1) (D2)
Setting side
User
User, system
System
MELSEC-Q
Constant
Others
K, H, $
2 Data type
Binary 16 bits
character string
Device name
Bit
7 - 41