Did Translation Number Conversion - NEC SL1000 Programming Manual

SL1000
Level
SA
Description
Use Program 22-11 : DID Translation Table Number Conversion to specify for each Translation
Program
Table entry (2000).
• The digits received by the system (eight maximum)
22
• The extension the system dials after translation (24 digits maximum)
• The name that should show on the dialed extension display when it rings (12 characters maxi-
mum)
• The Transfer Target - 1 and 2
If the Transfer Targets are busy or receive no answer, those calls are transferred to the final transfer desti-
nation (Program 22-10).
• Operation Mode
Use the following chart when entering and editing text for names. Press the key once for the first char-
acter, twice for the second character, etc. For example, to enter a C, press 2 three times.
When entering names in the procedures below, refer to this chart. Names can have up to 12 digits.
Use this keypad digit . . .
Input Data
2-234
Program 22 : Incoming Call Setup

22-11 : DID Translation Number Conversion

1
2
3
4
5
6
7
8
9
0
*
#
Clear/Back
Flash
Conversion Table Number
Key for Entering Names
Use this keypad digit . . .
Enter characters:
Enter characters: A-C, a-c, 2.
Enter characters: D-F, d-f, 3.
Enter characters: G-I, g-i, 4.
Enter characters: J-L, j-l, 5.
Enter characters: M-O, m-o, 6.
Enter characters: P-S, p-s, 7.
Enter characters: T-V, t-v, 8.
Enter characters: W-Z, w-z, 9.
Enter characters:
Enter characters:
# = Accepts an entry (only required if two letters on the same key are
needed - ex: TOM). Pressing # again = Space. (In system programming
mode, use the right arrow soft key instead to accept and/or add a space.)
Clear the character entry one character at a time.
Clear all the entries from the point of the flashing cursor and to the right.
1~800
Program 22 : Incoming Call Setup
Issue 0.1