Analog Trunk Data Setup - NEC SL1000 Programming Manual

Issue 0.1
Level
IN
Description
Use Program 14-02 : Analog Trunk Data Setup to set the basic options for each analog trunk port.
Refer to the table below for a description of each option, its range and default setting.
Input Data
Trunk Port Number
Item No. Item
01 Signaling Type (DP/DTMF)
This option sets the signaling type for
the trunk.
02 Ring Detect Type
This option sets Extended Ring
Detect or Immediate Ring Detect for
the trunk. For T1 loop/ground start
trunks, this option must be set to 1 for
the trunks to ring and light correctly.
03 Flash Type
This option selects the flash type
(open loop flash or ground). Always
set this option for open loop flash.
04 Hooking Type
This option lets you use Flash for
Timed Flash (Program 81-01-14) or
Disconnect (Program 81-01-15). (A
user implements Flash by pressing
the FLASH key while on a trunk call.)
05 Dial Tone Detection for Manually
Accessed Trunks
Use this option enable/disable dial
tone detection for directly accessed
trunks. If disabled, the system
outdials on the trunks without moni-
toring for dial tone.
06 Pause at 1st Digit after Line Seize
in Manual Dial Mode
07 DP to DTMF Conversion Options
Determine how a user can convert a
Dial Pulse (DP) call to a DTMF call.
For each trunk, set the type of DP to
DTMF conversion required. There
are three conversion options: Auto-
matic (0), Automatic and Manual (1),
or Manual (2).
Automatic:
DP to DTMF conversion occurs auto-
matically if the extension user waits
more than 10 seconds before dialing
the next digit.
Automatic and Manual:
DP to DTMF conversion occurs auto-
matically if the extension user waits
more than 10 seconds before dialing
the next digit. In addition, the user
can dial # to switch a DP trunk to
DTMF dialing.
Manual:
Users can dial # to switch a DP trunk
to DTMF dialing.
Programming Manual
Program 14 : Trunk, Basic Setup

14-02 : Analog Trunk Data Setup

Input Data
0 = Dial Pulse (10 PPS)
1 = DTMF
0 = Normal/delayed
1 = Immediate Ringing
0 = Open Loop Flash
1 = Ground
0 = Timed Flash (Hooking)
1 = Disconnect (Cut)
0 = Dial Tone Detection Not
Used
1 = Dial Tone Detection Used
0 = No Pause (No)
1 = Pause (Yes)
0 = Automatic
1 = Automatic and Manual
2 = Manual
SL1000
001~126
Related Pro-
Default
gram
2
0
0
1 81-01-14
81-01-15
1 21-01-04
1 21-01-06
2 21-01-03
2-89
Program
14