Definition Of The Effect Of The Tool Parameters - Siemens SINUMERIK 840D sl Function Manual

As in the case of "missing D number", the required parameter (T number) can be accessed
by the user for "missing T number" via the appropriate alarm (17191).
Note
In order to enable program correction, it stops immediately at the faulty Txx block.
The program text operation is also stopped when machine data:
MD22562 $MC_TOOL_CHANGE_ERROR_MODE Bit0=1 (response on errors in tool change).
18.2.7

Definition of the effect of the tool parameters

MD20360
The effect of the tool parameters on the transverse axis in connection with diameter
programming can be controlled selectively with the machine data:
MD20360 $MC_TOOL_PARAMETER_DEF_MASK (definition of tool parameters).
Details are described with the mentioned MD
DRF handwheel traversal with half distance
During DRF handwheel traversal, it is possible to move a transverse axis through only half the
distance of the specified increment as follows:
Specify the distance with handwheel via the machine data:
MD11346 $MN_HANDWHEEL_TRUE_DISTANCE = 1 (handwheel path or speed
specification)
Define the DRF offset in the transverse axis as a diameter offset with the machine data:
MD20360 $MC_TOOL_PARAMETER_DEF_MASK bit 9 = 1 (definition of tool parameters)
Deselecting an axial DRF compensation (DRFOF) also deletes an existing tool compensation
(handwheel override in tool direction).
Note
For further information about superimposed movements with the handwheel, please refer to:
References:
Function Manual, Extended Functions; Manual and Handwheel Travel (H1)
Programming Manual, Fundamentals
(The Programming Manual describes the complete technical program options in order to
deselect the DRF offset axis-specifically.)
Basic Functions
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
W1: Tool offset
18.2 Tool
1381