Siemens SINUMERIK 840D sl Function Manual page 1233

Machine data
MD35310 $MA_SPIND_POSIT_DELAY_TIME[<n>]
MD35550 $MA_DRILL_VELO_LIMIT[<n>]
Type of gear stage change
The type of gear stage change is set in machine data:
MD35010 $MA_GEAR_STEP_CHANGE_ENABLE
Bit
0
1
3
5
Requirement for a gear stage change
In principle, the gear stage change is only performed if the requested gear stage is not the
same as the active gear stage.
Parameter set selection during gear stage change
The servo parameter set is also changed over with the gear stage if:
MD35590 $MA_PARAMSET_CHANGE_ENABLE = 0 or 1
For further information, see Section "Parameter set selection during gear step change
(Page 1246)".
Basic Functions
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Value Meaning
0 The spindle motor is attached to the spindle directly (1:1) or with a non-variable trans‐
mission ratio (basic setting).
The machine data of the first gear stage is effective.
1 Spindle motor with up to five gear stages.
The gear stage change takes place:
● In oscillation mode
● At indefinite change position
0 Meaning as in Bit 0 = 0.
1 Meaning as in Bit 0 = 1, however, the gear stage change takes place at the configured
spindle position.
The change position is set in machine data:
MD35012 $MA_GEAR_STEP_CHANGE_POSITION
The position is approached in the current gear stage before the gear stage change.
If Bit 1 is set, then Bit 0 is ignored!
1 The gear stage change dialog between NCK and PLC is simulated.
1 The second gear stage data set is used while tapping with G331/G332 (see the following
paragraph "Second gear stage data set"). The bit must be set for the master spindle
used during the tapping.
S1: Spindles
16.4 Configurable gear adaptation
Meaning
Positioning delay time
Maximum speed for tapping with‐
out compensating chuck
1233