Table of Contents
Advertisement
MITSUBISHI CNC
4. Wiring and Connecting
4.7 Connecting the Signal Splitter
Connect a relay cable to the connecter EXT I/F for the connection of the signal splitter(FCU7-HN387).
Skip (sensor) signals (refer to Wiring and Connecting: Connecting the Skip Signal (Sensor)) and the signals
from manual pulse generator(s) (refer to Wiring and Connecting: Connecting the Manual Pulse Generator)
can be connected to the signal splitter.
Install the signal splitter on a DIN rail.
Q173NCCPU
EXT I/F
(Note) Neither the connector RIO nor TERMINAL of the signal splitter is currently available.
<Related items>
Cable drawing: "Cable: H010 Cable"
76
NC I/F
H010
FCU7-HN387
RIO1
Advertisement
Table of Contents
