Table of Contents
Advertisement
MITSUBISHI CNC
2. General Specifications
2.10 Terminal block for Dual Signal Module (Recommended)
Terminal block converter module FA-LTB40P, produced by MITSUBISHI ELECTRIC ENGINEERING, is recommended to
connect the dual signals to the dual signal module. Use the connection cable FA-CBL □□ FMV-M produced by
MITSUBISHI ELECTRIC ENGINEERING.
A dual signal module requires two units of terminal converter modules and two cables.
FA-CBL □□ FMV-M cable (length: 05 as 0.5m, 10 as 1m, 20 as 2m, 30 as 3m and 50 as 5m)
Connector and the terminal block
B20
A20
FCN40P
B1
A1
2
MIL40P
1
(Note 1) Connect 24VDC to the terminals No.37 and 39, OV to the terminals No.38 and 40.
(Note2) Input/output cables must be protected against damage and mechanical stress/movement.
The installation must be that short circuits between cores (of multicore cables) cannot be possible or do not
lead to hazardous situation.
(Note 3) EMG-Switches must employ 2 NC contacts and be of direct opening type. (IEC60947-5-1 Annex K,
IEC60947-5-5)
50
40
39
Connection diagram
Advertisement
Table of Contents
