Mitsubishi Electric C70 Connection Manual page 155

Date of revision Manual No.
Sep. 2010 IB(NA)1500261-H
Dec. 2010 IB(NA)1500261-J
Sixth edition created.
- Following chapters are corrected as "1.3 Component Modules" is updated.
- 2. General Specifications
- 4. Wiring and Connecting
- Following chapters are reviewed.
- 1.2 General Connection Diagram
- 1.3 Component Modules
- 3.3 Calculating Heat Generation by C70
- Following chapters are added.
- 2.11 I/O Extension Connector Unit
- 4.10 Connecting the I/O Extension Connector Unit
- Following chapters are deleted.
- "Appendix 2. Cable and Connector for CNC CPU"
- "Appendix 3. Servo/Spindle Cable and Connector Specifications (MDS-D/DH
Series)"
- "Appendix 4. Servo/Spindle Cable and Connector Specifications(MDS-D-SVJ3/
SPJ3 Series)"
- Added new contents in the following chapters.
- 2.5 CNC CPU Module (19) MPG, (13) EXT I/F
Timing chart for HA1/HB1 is added.
- 2.6 Battery Box for CNC CPU (Q173NCCPU)
Guideline when changing a battery is added.
- 2.8 Signal Splitter
Input condition and a figure for input/output circuit are added.
- 2.9 Manual Pulse Generator
HD60 is added
- Corrected the mistakes
Seventh edition created.
- Revised the explanation to support the newly-added power supply module
Q64PN, G302 cable, and G303 cable.
- 1.2 General Connection Diagram
- 1.3.1 CNC Control Unit
- 2.3 Power Supply
- 4.2 Wiring to the Power Supply Module
- 4.4 Connecting the GOT
- Appendix 2.11 G302 Cable
- Appendix 2.12 G303 Cable
- Changed the section Nos.according to the addition of Appendix 2.11 and 2.12.
- Revised the figures in Appendix 2.16-2.23
- Corrected the mistakes
Revision details