Chapter 1 Part Names - Mitsubishi Electric MELSEC iQ-R Series User Manual

1
PART NAMES
This chapter describes the names of each part of the RJ71GN11-T2.
(1)
(2)
(3)
(4)
(5)
No. Name Description
(1) RUN LED Indicates the operating status.
On: Normal operation
Off: Error ( MELSEC iQ-R CC-Link IE TSN User's Manual (Application))
*1
ERR LED Indicates the error status of the module.
On: Error or during error detection on all stations ( MELSEC iQ-R CC-Link IE TSN User's Manual (Application))
Flashing (500ms interval): A data link faulty station was detected (only for the master station).
Flashing (200ms interval): Error ( MELSEC iQ-R CC-Link IE TSN User's Manual (Application))
Off: Normal operation
MST LED Indicates the operating status.
On: Operating as a master station
Off: Operating as a local station
*1
D LINK LED
Indicates the cyclic transmission status.
On: Cyclic transmission being performed
Flashing: Cyclic transmission stopped
Off: Disconnected
P1 SD/RD LED Indicates the data sending/receiving status.
On: Data being sent or received
P2 SD/RD LED
Off: Data not sent nor received
(2) Dot matrix LED Displays the station number set for the module.
Station number or parameter not set: "  "
Master station: 0
Local station: 1 to 120
■At major error
All lights turn off. However, some major errors do not cause all lights to turn off. Check the RUN LED and ERR LED to see if a
major error has occurred.
■In Module Communication Test mode
Displays the module communication test result. ( MELSEC iQ-R CC-Link IE TSN User's Manual (Application))
■In offline mode
Displays "".
■When the module status setting is "Empty"
Displays "  "
(3) P1 Port for CC-Link IE TSN connection. Connect an Ethernet cable.
For wiring methods and wiring precautions, refer to the following.
(Page 35 WIRING)
L ER LED Indicates the port status.
On: Abnormal data received
Off: Normal data received
LINK LED Indicates the link status.
On: Link-up
Off: Link-down
(4) P2 Same as P1
L ER LED
LINK LED
1
1 PART NAMES
15