4.11 Removing Or Installing The Tilt Legs On The Multiline Terminal; 4.11.1 Remove Tilt Legs; Figure 5-67 Separating The Tilt Legs; Figure 5-68 Removing Tilt Legs From Multiline Terminal - NEC Univerge SV9100 System Hardware Manual

Issue 2.0

4.11 Removing or Installing the Tilt Legs on the Multiline Terminal

5-72
The Tilt Legs can be removed or installed on the DT series multiline terminal.

4.11.1 Remove Tilt Legs

1. Place the telephone on a flat surface (button side down).
2. Separate the Tilt Legs and place them flat against the telephone.
Refer to

Figure 5-67 Separating the Tilt Legs

3. Push downward (two arrows) and slide downward (refer to
5-68 Removing Tilt Legs from Multiline

Figure 5-68 Removing Tilt Legs from Multiline Terminal

4. Lift and remove the Tilt Legs.
Figure 5-67 Separating the Tilt
Installing DT Series Digital and IP Multiline Terminals
Legs.
Figure
Terminal).