Install Grounding On 9.5" Gateway Or Base Chassis; Install Ac Power Cord 9.5" Gateway Or Base Chassis; Install Additional Blades 9.5" Gateway Or Base Chassis; Apply Power To The 9.5" Gateway Or Base Chassis - NEC Univerge SV9100 System Hardware Manual

Issue 2.0
SV9100 System Hardware Manual
Figure 3-27 9.5" Chassis (Rear View)
For External Battery
(12V Connection)
3.4.1

Install Grounding on 9.5" Gateway or Base Chassis

1. Ensure the 9.5" chassis (CHS2UG GW or CHS2UG B) is powered off
and the AC power cord is unplugged.
2. Ground the chassis by connecting a 14 AWG wire from the FG lug on
the back side of the chassis to an electrical service ground (Connect
to grounding conductor (Less than 10 ohms)). Refer to
9.5" Chassis (Rear
3.4.2

Install AC Power Cord 9.5" Gateway or Base Chassis

Locate the supplied AC power cord and attach to the AC Inlet located on the
back of the chassis [refer to
3.4.3

Install Additional Blades 9.5" Gateway or Base Chassis

Refer to Chapter 4,
3.4.4

Apply Power to the 9.5" Gateway or Base Chassis

Refer to Chapter 4,
Ground
View).
Figure 3-27 9.5" Chassis (Rear
2.1 Installation and Safety Precautions on page
2.6 Powering Up the SV9100 System on page
CHS2UG B
Chassis
AC Inlet
Figure 3-27
View)].
4-4.
4-9.
3-23