Table of Contents
Advertisement
enabling Wi-Fi, the factory default parameters offer the highest security
and number of users. Change the default configuration to meet field
security requirements.
This procedure enables Wi-Fi and changes the default security passcode
(recommended). For non-default configuration or additional details click
Help from the Wi-Fi tab screen.
IMPORTANT NOTE: An XFC or XRC enabled as a Wi-Fi Access Point
does not provide bridging or routing between the wireless (Wi-Fi)
and the wired (Ethernet) networks.
Enable as a Wi-Fi Access Point:
1.
Install the antenna. See
2.
Configure the Network ID.
On the PCCU Entry mode navigation tree, select Communications.
3.
Select the Wi-Fi tab.
4.
Figure 10-7: Wi-Fi tab screen
Select the Enable Wi-Fi Access Point checkbox.
5.
Change the default security passcode by clicking Change.
6.
At the dialog box, type the factory default passcode: totalflow. Type
7.
and confirm a new passcode, and click OK. Take note of the new
6 2 | XSE RI ES G5 STA RT UP GUI DE | 21 0 60 0 1MNAA
2.10 Install
antenna.
Advertisement
Table of Contents
