Mitsubishi Electric MELSEC iQ-R Series User Manual page 85

CH1 Warning output setting value upper/upper limit
Set the upper/upper limit value of the warning output function.
For details on the warning output function, refer to the following.
Page 29 Warning Output Function
■Buffer memory addresses
The following shows the buffer memory addresses of this area.
Buffer memory name
CH Warning output setting value upper/upper limit
CH Warning output setting value upper/upper limit
(when Q series-compatible mode is used)
■Setting range
• The setting range is from 0 to 32767.
• For channels on which the set value is outside the setting range, a warning output setting value upper/upper limit setting
error (error code: 1AC1H) occurs.
• Set the value so that the condition of upper/upper limit  upper/lower limit > lower/upper limit  lower/lower limit is satisfied.
If a value that does not meet this condition is set, a warning output setting value setting error (error code: 1AC5H) will occur.
However, the value can be set such that upper/upper limit = upper/lower limit and lower/upper limit = lower/lower limit.
• The default values of the upper/upper limit, upper/lower limit, lower/upper limit, and lower/lower limit are 0, so change each
warning output setting value when using the warning output function.
■Enabling the setting
Turn on and off 'Operating condition setting request flag' (Y1).
■Default value
The default value is 0 for all channels.
CH1 Warning output setting value upper/lower limit
Set the upper/lower limit value of the warning output function.
For details on the warning output function, refer to the following.
Page 29 Warning Output Function
■Buffer memory addresses
The following shows the buffer memory addresses of this area.
Buffer memory name
CH Warning output setting value upper/lower limit
CH Warning output setting value upper/lower limit
(when Q series-compatible mode is used)
■Setting range
• The setting range is from 0 to 32767.
• For channels on which the set value is outside the setting range, a warning output setting value upper/lower limit setting
error (error code: 1AC2H) occurs.
• Set the value so that the condition of upper/upper limit  upper/lower limit > lower/upper limit  lower/lower limit is satisfied.
If a value that does not meet this condition is set, a warning output setting value setting error (error code: 1AC5H) will occur.
However, the value can be set such that upper/upper limit = upper/lower limit and lower/upper limit = lower/lower limit.
• The default values of the upper/upper limit, upper/lower limit, lower/upper limit, and lower/lower limit are 0, so change each
warning output setting value when using the warning output function.
■Enabling the setting
Turn on and off 'Operating condition setting request flag' (Y1).
■Default value
The default value is 0 for all channels.
CH1 CH2 CH3
137 169 201
19 51 83
CH1 CH2 CH3
138 170 202
20 52 84
CH4 CH5 CH6
233 265 297
115 147 179
CH4 CH5 CH6
234 266 298
116 148 180
Appendix 3 Buffer Memory Areas
CH7 CH8
329 361
211 243
A
CH7 CH8
330 362
212 244
APPX
83