Connecting Terminating Resistors - Mitsubishi Electric AJ65SBT2B-64AD User Manual

5.3 Connecting Terminating Resistors

The AJ65SBT2B-64AD has a built-in terminating resistor of 110 .
There is no need to connect a terminating resistor externally.
When using the AJ65SBT2B-64AD at the network termination, turn on
the L TER. Switch. The factory default setting of the switch is off.
(1) Precautions
(a) Move the L TER. switch until it clicks.
(b) The built-in terminating resistor cannot be used in the following
cases.
• There is a possibility that the AJ65SBT2B-64AD will be
replaced during data link.
• A CC-Link system is configured using CC-Link dedicated
cables of 130 .
Click
12