Mitsubishi Electric AJ65SBT2B-64AD User Manual page 20

Item
Built-in terminating resistor
Communication
part, module
power supply
part
Partie
External
communication,
connection
Partie
system
alimentation du
Système
module
des
connexions
externes
I/O part
Partie entrée/
sortie
Applicable wire size
Taille du fil à utiliser
Applicable solderless
terminal
Borne sans soudure à utiliser
Module mounting screw
Applicable DIN rail
External power supply
Weight
*1 Except when receiving noise influence.
*2 These values indicate the maximum resolution with user range setting.
*3 This value indicates a momentary input current value at which the built-in
resistor will not be broken.
*4 The number of times that the SELECT/SET switch is set to SET in test mode.
7-point two-piece terminal block
M3 5.2 screw (tightening torque range: 0.59 to 0.88N•m)
Applicable solderless terminal: 2 or less
Plaque à bornes 7-points deux pièces
M3 5,2 Couple de serrage : 0,59 à 0,88 N•m
Borne sans soudure à utiliser : 2 ou moins
18-point two-piece terminal block
M3 5.2 screw (tightening torque range: 0.59 to 0.88N•m)
Applicable solderless terminal: 2 or less
Plaque à bornes 18-points deux pièces
M3 5,2 Couple de serrage : 0,59 à 0,88 N•m
Borne sans soudure à utiliser : 2 ou moins
• RAV1.25-3 (compliant with JIS C 2805)
[Applicable wire size: 0.3 to 1.25mm
• V2-MS3, RAP2-3SL, TGV2-3N
[Applicable wire size: 1.25 to 2.0mm
• RAV1.25-3 (conforme à la norme JIS C 2805)
[Taille de fil à utiliser : 0,3 à 1,25mm
• V2-MS3, RAP2-3SL, TGV2-3N
[Taille de fil à utiliser : 1,25 à 2,0mm
M4 screw 0.7mm 16mm or more (tightening torque range:
Mountable with a DIN rail
TH35-7.5Fe, TH35-7.5Al (compliant with IEC 60715)
24VDC (ripple ratio: within 5%)
(allowable voltage range 20.4 to 28.8VDC)
Inrush current: 1.6A, 4.0ms or less
Current consumption: 0.12A (24VDC)
5
AJ65SBT2B-64AD
Provided (110 )
2
0.3 to 2.0mm
2
0,3 à 2,0 mm
2
]
2
]
2
]
2
]
0.78 to 1.08 N•m)
0.25kg