Supported Single-Line Diagram Symbols - ABB 650 Series Engineering Manual

1MRK 511 284-UEN A
6.2.2
650 series
Engineering manual
that is not connected to a symbol may be done in any line width in the range 1 - 5. But
it needs to be simple connection points to be drawn.
For the procedure to draw lines when the apparatus symbols are placed, see
1. Place the apparatus or transformer symbols by drag and drop in a raster box.
2. Place the connections symbols by drag and drop in a raster box.
3. Click the Link icon to enable direct line drawing.
4. Center the mouse pointer on the center of a connection point; visible in two circles
at the endpoints of a line, to draw a line.
5. Click to start and move the mouse pointer to the destination connection point.
Center once again the mouse pointer and click to drop the line.
6. Draw all line elements that are necessary.
7. Click Select in the menu bar to finish the line drawing.
IEC05000598 V2 EN
Figure 56: GDE: Drawing a line

Supported single-line diagram symbols

Table 6: Supported symbols
Category IEC Symbol Name
Connections Junction
Connections Busbar junction
Connections Earth
Table continues on next page
Local HMI engineering
IEC05000598-2-en.vsd
Symbol IEC Symbol
Type Definitions
1
2
10
Section 6
Figure 56.
ANSI Y32.2/ Function Block
IEEE 315 Type
Symbol
Definitions
77