Canon Inner Booklet Trimmer-A1 Service Manual page 63

5
Installation > Installation Procedure > Installing the Trimmer Unit
11
11) At the trimmer unit, remove one resin ring and one bushing not to drop the pin inside the
gear. At the saddle unit, remove one resin ring and one resin washer. (The resin washer is no
longer required.)
13
13) Attach the supplied upper cover using the supplied four
screws (bind-head, M4 x 6).
x4
5 Installation > Installation Procedure > Installing the Trimmer Unit
F-5-25 F-5-25
14
14) Lift up the saddle unit- finisher communication cable.
F-5-27 F-5-27
12
12) Install the supplied drive belt and the supplied metal platte. Then, attach the bushing and two resin rings
removed in step11. Install the metal plate removed in step 9 discussed in " Making Preparations for Installing
the Finisher" using one screw.
x1
15
15) Install the saddle unit
at the original position.
F-5-28 F-5-28
F-5-26 F-5-26
16
16) Install the inner
cover using three
screws.
5-10
5-10