Canon Inner Booklet Trimmer-A1 Service Manual page 58

5
Installation > Installation Procedure > Making Preparations for Installing the Finisher
9
9) Remove one screw, and then remove the metal plate.
After removing the metal plate, move the pully to the front and remove the belt.
The removed screw/metal plate are attached again at the rear step.
(The belt is no longer required.)
x1
10
10) Remove two screws, and then remove the feed unit.
(The feed unit/the two screws are no longer required.)
5
Installation > Installation Procedure > Making Preparations for Installing the Finisher
11
11) Remove three screws, and then remove the static eliminator unit.
The removed screw is used next step.
(The static eliminator/the two screws are no longer required.)
x2
x3
F-5-11 F-5-11
F-5-10 F-5-10
F-5-12 F-5-12
5-5
5-5