Mtu - Siemens SIMATIC NET Configuration Manual

Configuration
3.1 System
The parameters have the following meaning:
Parameters
transmit
receive
Note
Disabling both options
When you call this command, you can only select one option.
If you want to disable both options, call up the command again.
Result
The setting is configured.
Further notes
You enable the sending or receipt of LLDP packets with the
You display the status of LLDP with the
3.1.10.7

mtu

Description
With this command, you configure the size of the Maximum Transmission Unit (MTU) for an
interface.
Requirement
● The Interface must be shut down.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
mtu <frame-size(64-1514)>
64
Description
the sending of LLDP packets is enabled
the receipt of LLDP packets is disabled
show lldp status
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
command.
lldp
command.
Configuration Manual, 10/2015, C79000-G8976-C351-05