No Snmp Targetaddr; Snmp Targetparams - Siemens SIMATIC NET Configuration Manual

Further notes
You delete the SNMP target address with the
You display the SNMP target address with the
You configure the SNMP target parameters with the
You display the SNMP target parameters with the
7.4.2.15

no snmp targetaddr

Description
With this command, you delete the SNMP target address.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp targetaddr <TargetAddressName>
The parameter has the following meaning:
Parameter
TargetAddressName
Result
The SNMP target address is deleted.
Further notes
You change the SNMP target address with the
You display the SNMP target address with the
7.4.2.16

snmp targetparams

Description
With this command, you configure the SNMP target parameters.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
no snmp targetaddr
show snmp targetaddr
Description
SNMP target address
show snmp targetaddr
command.
command.
snmp targetparams
show snmp targetparam
Range of values / note
max. 32 characters
command.
snmp targetaddr
command.
Network protocols
7.4 SNMP
command.
command.
345