Motorola PTP 800 User Manual page 315

User Guide: PTP 800 Licensed Ethernet Microwave
Attribute
Management Port Auto
Neg Advertisement
Data Port Wireless
Down Alert
Management Port
Wireless Down Alert
Data Port Ethernet
Media Type To Use
Data Port Copper Auto
Negotiation
Data Port Copper Auto
Neg Advertisement
phn-1478_005v000
Apr 2010
Select the data rate that the auto-negotiation mechanism
will advertise as available on the the out-of-band
management Ethernet interface. Use the same setting for
both ends of the link.
Only select a data rate that is within the capability of
connected network equipment, otherwise loss of service
may occur.
The new setting will only take effect after a system
reboot.
When enabled, this causes the Ethernet link to be
dropped briefly when the wireless link drops. This signals
to the connected network equipment that this link is no
longer available. Connected Ethernet switches can be
configured to forward Ethernet frames on an alternate
path identified using the Spanning Tree Protocol (STP).
As above.
'Auto with Fiber Preference' means that if a supported
SFP module is present, the Ethernet service connects
through fiber and the copper data port is disabled.
'Force Copper' means that the Ethernet service connects
through the copper port only and the Fiber SFP interface
is disabled.
'Enabled' means that configuration is automatically
negotiated. This is the default setting.
'Disabled' means that configuration is forced.
Use the same setting for both ends of the link.
Select the data rate that the auto-negotiation mechanism
will advertise as available. Use the same setting for both
ends of the link.
Only select a data rate that is within the capability of
connected network equipment, otherwise loss of service
may occur.
The new setting will only take effect after a system
reboot.
Configuring the IP and Ethernet interfaces
Meaning
6-25