User Guide: PTP 800 Licensed Ethernet Microwave
Step 5: Starting antenna alignment
Perform this task to start antenna alignment.
WARNING
To start antenna alignment, proceed as follows:
Procedure 5-23 Start antenna alignment
The Step 5: Start Antenna Alignment page is displayed
1
To start alignment, check that no personnel are in front of the antenna, then
2
select Start Alignment.
3
To defer alignment until later, select Skip Alignment. This cancels the
Install Wizard without doing alignment, but configuration changes are saved.
If the transmitter was previously enabled then it remains enabled. If
previously muted then it remains muted. The Step 6: Configuration Complete
page is displayed
Figure 5-36 Step 5: Start Antenna Alignment page
phn-1478_005v000
Apr 2010
Do not start antenna alignment until it is safe for the antennas to
radiate RF, that is, until the antennas and ODUs have been
installed on the masts or poles and no personnel are in front of
the antennas.
(Figure
5-37).
Installation wizard
(Figure
5-36).
5-101