Table of Contents
Advertisement
User Guide: PTP 800 Licensed Ethernet Microwave
Installation wizard
Use the Installation Wizard to enter initial configuration details, to set the system
into alignment mode, to achieve the lowest possible link loss through correct
antenna alignment, and to report on the performance of the configured link. The
wizard handles the important configuration settings that must be set to comply
with the individual license conditions. These settings can only be changed using the
Installation Wizard.
Prerequisites for the installation wizard:
x
Complete hardware installation at both link ends.
x
Use the LINKPlanner to calculate the expected receive power.
x
Perform
x
Ensure that all license details are available, including maximum EIRP,
antenna gain, transmit and receive frequencies, channel bandwidth.
x
Select a link name that is unique to this link.
Step 1: Configuring equipment parameters
Perform this task to enter the link equipment parameters.
CAUTION
To configure link equipment, proceed as follows:
Procedure 5-19 Configure link equipment
From the left hand menu, select System Administration. The System
1
Administration Login page
2
The System Administration Password is blank by default. Leave it blank and
select Login. The System Administration menu
3
From the menu, select Installation Wizard. Step 1: Equipment
Configuration page is displayed
4
Enter the equipment configuration attributes
5
Select Next.
phn-1478_005v000
Apr 2010
Connecting the CMU to a PC or workstation
Link Name must be the same at both ends of the link, otherwise the link
will not work.
(Figure
6-4) is displayed.
(Figure
5-29).
(Table
Installation wizard
on page 5-87.
(Figure
6-5) is displayed.
5-6).
5-91
Advertisement
Table of Contents
