GE t60 Instruction Manual page 78

4.2 FACEPLATE INTERFACE
7. When the "NEW SETTING HAS BEEN STORED" message appears, the relay will be in "Programmed" state and the
In Service LED will turn on.
e) ENTERING INITIAL PASSWORDS
To enter the initial Setting (or Command) Password, proceed as follows:
1. Press the
sage appears on the display.
2. Press the MESSAGE
3. Press the MESSAGE
display.
SETTINGS
SETTINGS
PRODUCT SETUP
4
4. After the 'CHANGE...PASSWORD' message appears on the display, press the VALUE
change the selection to Yes.
5. Press the key and the display will prompt you to 'ENTER NEW PASSWORD'.
6. Type in a numerical password (up to 10 characters) and press the
7. When the 'VERIFY NEW PASSWORD' is displayed, re-type in the same password and press
CHANGE SETTING
PASSWORD: No
CHANGE SETTING
PASSWORD: Yes
8. When the 'NEW PASSWORD HAS BEEN STORED' message appears, your new Setting (or Command) Password will
be active.
f) CHANGING EXISTING PASSWORDS
To change an existing password, follow the instructions in the previous section with the following exception. A message will
prompt you to type in the existing password (for each security level) before a new password can be entered.
In the event that a password has been lost (forgotten), submit the corresponding Encrypted Password from the
menu to the Factory for decoding.
SECURITY
4-12
key until the 'SETTINGS' header flashes momentarily and the 'SETTINGS PRODUCT SETUP' mes-
key until the 'ACCESS LEVEL:' message appears on the display.
key until the 'CHANGE SETTING (or COMMAND) PASSWORD:' message appears on the
ENTER NEW
PASSWORD: ##########
T60 Transformer Management Relay
PASSWORD
SECURITY
key.
4 HUMAN INTERFACES
ACCESS LEVEL:
Restricted
CHANGE COMMAND
PASSWORD: No
CHANGE SETTING
PASSWORD: No
ENCRYPTED COMMAND
PASSWORD: ----------
ENCRYPTED SETTING
PASSWORD: ----------
key or the VALUE key to
.
VERIFY NEW
PASSWORD: ##########
NEW PASSWORD
HAS BEEN STORED
PASSWORD
GE Multilin