GE t60 Instruction Manual page 72

4.2 FACEPLATE INTERFACE
b) LED PANELS 2 AND 3
These panels provide 48 amber LED indicators whose operation is controlled by the user. Support for applying a custom-
ized label beside every LED is provided.
User customization of LED operation is of maximum benefit in installations where languages other than English are used to
communicate with operators. Refer to the User-Programmable LEDs section in Chapter 5 for the settings used to program
the operation of the LEDs on these panels.
c) DEFAULT LABELS FOR LED PANEL 2
4
The default labels represent the following:
• GROUP 1...6: The illuminated GROUP is the active settings group.
Firmware revisions 2.9x and earlier support eight user setting groups; revisions 3.0x and higher support
six setting groups. For convenience of users using earlier firmware revisions, the relay panel shows eight
setting groups. Please note that the LEDs, despite their default labels, are fully user-programmable.
NOTE
The relay is shipped with the default label for the LED panel 2. The LEDs, however, are not pre-programmed. To mach the
pre-printed label, the LED settings must be entered by the user as shown in the USER-PROGRAMMABLE LEDs section of
the SETTINGS chapter. The LEDs are fully user-programmable. The default labels can be replaced by user-printed labels
for both LED panels 2 and 3 as explained in the next section.
4-6
Figure 4–5: LED PANELS 2 AND 3 (INDEX TEMPLATE)
SETTINGS IN USE
GROUP 1
GROUP 2
GROUP 3
GROUP 4
GROUP 5
GROUP 6
GROUP 7
GROUP 8
Figure 4–6: LED PANEL 2 (DEFAULT LABEL)
T60 Transformer Management Relay
4 HUMAN INTERFACES
GE Multilin