Connecting The Control Cables; Terminals - ABB ACS800 Hardware Manual

Connecting the control cables

Lead the cable through the control cable entry (1).
Connect the control cables as described below. Connect the conductors to the
appropriate detachable terminals of the RMIO board [refer to chapter
and I/O board

Terminals

Control panel
Optional module 1
Control cable
grounding: see
section 360
degrees
grounding
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
(RMIO)]. Tighten the screws to secure the connection.
1
View of frame size R6
Optional module 2
DDCS communication module: RDCO.
Channel CH1 is used for the internal communication
between the line-side and motor-side converters.
Detachable connection terminals (pull up)
67
Motor control
Electrical installation