Fixed Parameters With The Acs800-31 And Acs800-U31 - ABB ACS800 Hardware Manual

Fixed parameters with the ACS800-31 and ACS800-U31

When the IGBT Supply Control Program is loaded into the ACS800-31 or ACS800-
U31, the following parameters are set to the default values given in the table below.
Parameter
11.01
11.02
98.01
98.02
30.02
70.01
70.19
70.20
71.01
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
DC REF SELECT
Q REF SELECT
COMMAND SEL
COMM. MODULE
EARTH FAULT
CH0 NODE ADDR
CH0 HW CONNECTION RING
CH3 HW CONNECTION RING
CH0 DRIVEBUS MODE NO
Default value
FIELDBUS
PARAM 24.02
MCW. Note: If par. 16.15 I/O
START MODE is set to DI2 LEVEL,
the default value is changed to I/O
on the next RMIO board power-up.
INVERTER
FAULT.
Note: The ACS800-31/U31 line
converter is not equipped with
internal earth fault supervision.
120
If changed,
the default values will be
restored on the next power-
up.
the default values will not
be restored on the next
power-up. Do not change.
If the default values are
changed, the drive will not
operate.
Actual signals and parameters
93