Mipcall Parameters; Mipopen, Open A Socket (Udp Or Tcp) - Motorola AT Commands G24-L Developer's Manual

The following table shows the +MIPCALL parameters.
<Parameter>
<status>
"APN"
"User name"
"Password"
Local
IP-address
Example
AT+MIPCALL=1,"internet","User1","Pswd"//Connecting the provider 'Orange' and getting an IP
+MIPCALL: "123.145.167.230"
AT+MIPCALL=0
OK

+MIPOPEN, Open a Socket (UDP or TCP)

This command causes the G24-L to initialize a new socket and open a connection with a remote
side. Each socket allocates an accumulating buffer whose size is 1372 bytes.
Note:
Command Type
Set
April 15, 2008
Table 3-195: +MIPCALL Parameters
0 Disconnect
1 Connected
APN of service provider (in quotation marks). Contact your service provider for
details.
User name in provider server (in quotation marks). Contact your service provider for
details.
Password for provider server (in quotation marks). Contact your service provider for
details.
IP address given by server after PPP negotiation.
//The terminal hangs up the link
The +MIPOPEN command returns a +MIPSTAT unsolicited event if it fails, for example,
if it was rejected by the remote side.
MIPxxx is a complete set of GPRS commands. This set should not be used with other
GPRS commands, such as CGATT, CGACT, and so on.
Syntax
+MIPOPEN=
<Socket ID>,
<Source Port>,
<"Destination
Address">,
<Destination
Port>, <Protocol>
G24-L AT Commands Reference Manual
Chapter 3: AT Commands Reference
Description
Response/Action
OK
+MIPOPEN: <Socket ID>,<State>
or:
ERROR: <err>
Remarks
3-277