Modem Configuration and Profile
Example
ATS36?
005
OK
ATS0=3
OK
ATS0?
003
OK
S2
This command handles the selection of the escape characters, which are stored in S-Register 2,
and specifies the escape character used in CSD connections.
Command
Type
Set
Read
The following table shows the S2 parameters.
<Parameter>
<escape_character>
3-196
Syntax
Response/Action
S2=<escape_character>
OK
+CME ERROR: <err>
S2?
<escape_character>
OK
+CME ERROR: <err>
Table 3-131: S2 Parameters
CSD escape character.
Range is 0 to 255. The default value is 43 ("+").
G24-L AT Commands Reference Manual
Remarks
The Set command sets the CSD escape
character value if all parameters are
valid.
The Read command displays the
currently defined escape character for
CSD connections.
Description
April 15, 2008