Send Dtmf - Motorola AT Commands G24-L Developer's Manual

Send DTMF

This proactive SIM service command requests the G24-L to send a DTMF string after
successfully establishing a call. This command can be used at any time during a call. The G24-L
does not locally generate audible DTMF tones to play to the user.
This command can be activated/deactivated by the user using the command +MTKP=24. The
setting defined by the user is retained during the currently active call and is restored after a power
cycle. If a DTMF command is sent to the G24-L while this command is disabled, the G24-L
sends an "Unable to process" terminal response to the SIM.
The terminal response indicating that the command has been performed successfully is sent after
the complete DTMF string is sent to the network by the G24-L.If the command is sent in idle
mode, or if a call is terminated or put on hold before the complete DTMF string is sent to the
network, the G24-L informs the SIM using terminal response 20, with the additional information
"Not in speech call". If the user indicates the need to end the proactive SIM application session
while the G24-L is sending the DTMF string, the G24-L stops sending the string and sends the
following terminal response, "Proactive SIM application session terminated by the user".
If the SIM includes an alpha identifier in the command, the G24-L displays this string for the user
in the form of a +MTKP unsolicited response. In all other cases, no information is sent to the user.
Command Type
Set
Unsolicited
Response
Read
April 15, 2008
Syntax
+MTKP=24,<enable OK
/disable>
or:
+CME ERROR: <err>
+MTKP=24,<alpha identifier
string>
+MTKP? +MTKP: 24,<status>
G24-L AT Commands Reference Manual
Chapter 3: AT Commands Reference
Response/Action Remarks
The Set command
activates and deactivates
the send DTMF
command.
The Read command
displays the current status
of the send DTMF
command.
3-263