Link Layer Status Codes; Application Layer Status Codes - ABB COM600 Series User Manual
Version 5.0, dnp 3.0 serial slave opc
Hide thumbs
Also See for COM600 Series:
- Data historian operator's manual (140 pages) ,
- User manual (104 pages) ,
- Configuration manual (66 pages)
Table of Contents
Advertisement
5.3.2.
5.3.3.
64
COM600 series, Version 5.0
DNP 3.0 Serial Slave (OPC) User's Manual
Link layer status codes
17650
The Data Flow Control ( DFC) bit of the messages from the master is set for
more than 15 seconds.
17651
The DCD or CTS signal or the end of the transmitted message is not received
in correct time.
17652
Timeout while waiting for an acknowledgment to a request.
17654
The application level sends a command before the communication between
the master and the slave is established.
17655
The Data Flow Control bit of the messages from the master is set for too long.
17656
The slave does not receive a reply from the master.
17657
The channel has been set in use.
17658
The channel has been set out of use.
17659
The protocol stack out of buffers error.
17670
The value written to one of the channel properties is incorrect.
Application layer status codes
13901
The value set to a property of the device is incorrect.
13904
No more events can be written to one of the unsolicited message queues
since the queue is full.
13905
Internal message buffer full error.
13906
Internal message filling error.
13907
The used data object type is not supported.
13909
Internal data overflow error.
13910
The device is in the suspended state. The reason for this can be that the link
is not properly established (for example incorrect cable wiring) or the master
station does not respond.
13911
Internal message sending error.
13913
A command is sent to a channel with a non-established communication.
13914
Internal out of buffers error.
13918
The device has been set out of use.
13919
The device has been set in use.
13924
Internal buffer error.
13925
There is not any preceding command with the address given when confirming
a command. Either the address is incorrect or the command has not been
received.
13926
Internal software error.
13927
The channel to which the device is created is incorrect.
13931
The CODE item of a received control block message is unknown.
1MRS755495
Advertisement
Table of Contents
