3.4.
3.4.1.
20
COM600 series, Version 5.0
DNP 3.0 Serial Slave (OPC) User's Manual
4. Drag and drop the logical node into the Cross-References function. The data objects
within the logical node appear now in the Cross-References function.
Note that only data objects that have been given a non zero information address in
the Cross-References table will be connected to the DNP Serial IED.
5. At this point, click Save to create the cross-references (to connect the data objects
to the DNP Serial IED).
Figure 3.3.5-1 Cross-References window
For more detailed information about the Cross-References function, see Cross-References
function in COM600 User's Manual.
Configuring objects
General information about configuring data objects
You can configure data objects either in the Object Properties window or in the Cross
References window.
The actual configuration in Object Properties window by using the COM600 Station
Automation Builder 600 (SAB600) is performed as described in 3.2, Overview of con-
figuration.
The parameters are stored in Object properties in the COM600 Station Automation
Builder 600 (SAB600) (see the tables for each data object type).
1MRS755495
SAB600_DNP_Serial_Slave_Cross_References.png