HP 12500 Series Configuration Manual page 68

Figure 15 Network diagram
802.1X user
Configuration procedure
NOTE:
Configure the interfaces and VLANs as shown in
address manually or automatically and can access resources in the authorized VLAN after passing
authentication.
Configure the RADIUS server (when the server runs on IMC PLAT 5.1 SP1)
1.
NOTE:
This section assumes that the RADIUS server runs on IMC PLAT 5.1 SP1 (E0202P05), and IMC UAM 5.1
SP1 (E0301P03)
# Add an access device.
Log in to IMC, click the Service tab, and select User Access Manager > Access Device
Management > Access Device from the navigation tree. Then, click Add to configure an access
device as follows:
Set the shared key for secure authentication communication to expert.
a.
Set the ports for authentication to 1812.
b.
Select LAN Access Service as the service type.
c.
Select HP(General) as the access device type.
d.
Select the access device from the device list or manually add the device with the IP address
e.
10.1.1.2.
Leave the default settings for other parameters and click OK.
f.
NOTE:
The IP address of the access device specified here must be the same as the source IP address of the RADIUS
packets sent from the device, which is chosen in this order:
The IP address specified with the nas-ip command on the device
•
The IP address specified with the radius nas-ip command on the device
•
• The IP address of the outbound interface (the default)
RADIUS server
10.1.1.1/24
Vlan-int3
10.1.1.2/24
Vlan-int2 Vlan-int4
GE3/0/1
Switch
Internet
Figure 15. Make sure that the host can get a new IP
58