HP 12500 Series Configuration Manual page 287

Figure 95 Network diagram
Configuration procedure
Add all the ports on Switch B into VLAN 10, and configure the IP address of VLAN-interface 10 on
1.
Switch A. (Details not shown.)
Configure DHCP address pool 0 on Switch A as a DHCP server.
2.
<SwitchA> system-view
[SwitchA] dhcp enable
[SwitchA] dhcp server ip-pool 0
[SwitchA-dhcp-pool-0] network 10.1.1.0 mask 255.255.255.0
Configure Host A and Host B as 802.1X clients (details not shown) and configure them to upload
3.
IP addresses for ARP detection.
Configure Switch B:
4.
# Enable the 802.1X function.
<SwitchB> system-view
[SwitchB] dot1x
[SwitchB] interface GigabitEthernet 3/0/1
[SwitchB-GigabitEthernet3/0/1] dot1x
[SwitchB-GigabitEthernet3/0/1] quit
[SwitchB] interface GigabitEthernet 3/0/2
[SwitchB-GigabitEthernet3/0/2] dot1x
[SwitchB-GigabitEthernet3/0/2] quit
# Add local access user test.
[SwitchB] local-user test
[SwitchB-luser-test] service-type lan-access
[SwitchB-luser-test] password simple test
[SwitchB-luser-test] quit
# Enable ARP detection for VLAN 10.
[SwitchB] vlan 10
[SwitchB-vlan10] arp detection enable
# Configure the upstream port as a trusted port and the downstream ports as untrusted ports (a port
is an untrusted port by default).
277