HP 12500 Series Configuration Manual page 300

to pass. Enable strict URPF check on VLAN-interface 10 of Switch A to allow use of the default route for
URPF check.
Figure 101 Network diagram
Configuration procedure
Configure Switch B:
1.
# Create VLAN 10.
<SwitchB> system-view
[SwitchB] vlan 10
[SwitchB-vlan10] quit
# Specify the IP address for VLAN-interface 10.
[SwitchB] interface vlan-interface 10
[SwitchB-Vlan-interface10] ip address 1.1.1.2 255.255.255.0
# Enable strict URPF check on VLAN-interface 10.
[SwitchB-Vlan-interface10] ip urpf strict
Configure Switch A:
2.
# Create VLAN 10.
<SwitchA> system-view
[SwitchA] vlan 10
[SwitchA-vlan10] quit
# Specify the IP address for VLAN-interface 10.
[SwitchA] interface vlan-interface 10
[SwitchA-Vlan-interface10] ip address 1.1.1.1 255.255.255.0
# Enable strict URPF check on VLAN-interface 10.
[SwitchA-Vlan-interface10] ip urpf strict
290