Displaying And Maintaining Fips; Fips Configuration Example - HP 12500 Series Configuration Manual

Step
2. Trigger a self-test.

Displaying and maintaining FIPS

Task
Display FIPS state.

FIPS configuration example

Network requirements
Configure the switch to work in FIPS mode and create a local user for the PC so that PC can log in to the
switch in FIPS mode.
Figure 109 Network diagram
Configuration procedure
Configure the switch:
1.
# Enable the FIPS mode.
<Sysname> system-view
[Sysname] fips mode enable
# Enable the password control function.
[Sysname] password-control enable
# Create a local user named test, and set its service type as terminal, privilege level as 3, and password
as AAbbcc1234%. The password must contain both uppercase and lowercase letters, digits, and special
characters.
[Sysname] local-user test
[Sysname-luser-test] service-type terminal
[Sysname-luser-test] authorization-attribute level 3
[Sysname-luser-test] password
Password:***********
Confirm :***********
Updating user(s) information, please wait...........
[Sysname-luser-test] quit
# Save the configuration.
[Sysname] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
flash:/startup.cfg exists, overwrite? [Y/N]:y
Command
fips self-test
Command
display fips status
321
Remarks
N/A
Remarks
Available in any view.