GE T60 Instruction Manual page 88

4.2 FACEPLATE INTERFACE
b) LED PANELS 2 AND 3
These panels provide 48 amber LED indicators whose operation is controlled by the user. Support for applying a custom-
ized label beside every LED is provided.
User customization of LED operation is of maximum benefit in installations where languages other than English are used to
communicate with operators. Refer to the User-Programmable LEDs section in Chapter 5 for the settings used to program
the operation of the LEDs on these panels.
4
USER-PROGRAMMABLE LEDS
c) DEFAULT LABELS FOR LED PANEL 2
The default labels are intended to represent:
• GROUP 1...6: The illuminated GROUP is the active settings group.
• SYNCHROCHECK NO1(2) IN-SYNCH: Voltages have satisfied the synchrocheck element.
Firmware revisions 2.9x and earlier support eight user setting groups; revisions 3.0x and higher support
six setting groups. For convenience of users using earlier firmware revisions, the relay panel shows eight
NOTE
setting groups. Please note that the LEDs, despite their default labels, are fully user-programmable.
The relay is shipped with the default label for the LED panel 2. The LEDs, however, are not pre-programmed. To match the
pre-printed label, the LED settings must be entered as shown in the User-Programmable LEDs section of Chapter 5. The
LEDs are fully user-programmable. The default labels can be replaced by user-printed labels for both panels as explained
in the following section.
4-6
Courtesy of NationalSwitchgear.com
Figure 4–5: LED PANELS 2 AND 3 (INDEX TEMPLATE)
SETTINGS IN USE
Figure 4–6: LED PANEL 2 (DEFAULT LABEL)
T60 Transformer Management Relay
4 HUMAN INTERFACES
USER-PROGRAMMABLE LEDS
842783A1.CDR
842782A1.CDR
GE Multilin