GE T60 Instruction Manual page 115

5 SETTINGS
The general transmission settings are shown below:
PATH: SETTINGS PRODUCT SETUP
GENERAL
The
DEFAULT GSSE/GOOSE UPDATE TIME
put state changes to be sent. When remote output data changes, GSSE or GOOSE messages are sent immediately. This
setting controls the steady-state 'heartbeat' time interval.
The
DEFAULT GSSE/GOOSE UPDATE TIME
The GSSE settings are shown below:
PATH: SETTINGS PRODUCT SETUP
GSSE
MESSAGE
MESSAGE
These settings are applicable to GSSE only. If the fixed GOOSE function is enabled, GSSE messages are not transmitted.
The setting represents the IEC 61850 GSSE application ID name string sent as part of each GSSE message. This
GSSE ID
string identifies the GSSE message to the receiving device. In T60 releases previous to 5.0x, this name string was repre-
sented by the
RELAY NAME
The fixed GOOSE settings are shown below:
PATH: SETTINGS PRODUCT...
FIXED GOOSE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
These settings are applicable to fixed (DNA/UserSt) GOOSE only.
The setting represents the IEC 61850 GOOSE application ID (GoID) name string sent as part of each GOOSE
GOOSE ID
message. This string identifies the GOOSE message to the receiving device. In revisions previous to 5.0x, this name string
was represented by the
The setting allows the destination Ethernet MAC address to be set. This address must be a multicast
DESTINATION MAC
address; the least significant bit of the first byte must be set. In T60 releases previous to 5.0x, the destination Ethernet MAC
address was determined automatically by taking the sending MAC address (that is, the unique, local MAC address of the
T60) and setting the multicast bit.
GE Multilin
Courtesy of NationalSwitchgear.com
COMMUNICATIONS
DEFAULT GSSE/GOOSE
UPDATE TIME: 60 s
sets the time between GSSE or GOOSE messages when there are no remote out-
setting is applicable to GSSE, fixed T60 GOOSE, and configurable GOOSE.
COMMUNICATIONS
GSSE FUNCTION:
Enabled
GSSE ID:
GSSEOut
DESTINATION MAC:
000000000000
setting.
COMMUNICATIONS
GOOSE FUNCTION:
Disabled
GOOSE ID:
GOOSEOut
DESTINATION MAC:
000000000000
GOOSE VLAN PRIORITY:
4
GOOSE VLAN ID:
0
GOOSE ETYPE APPID:
0
setting.
RELAY NAME
T60 Transformer Management Relay
IEC 61850... GSSE/GOOSE...
Range: 1 to 60 s in steps of 1
IEC 61850... GSSE/GOOSE...
Range: Enabled, Disabled
Range: 65-character ASCII string
Range: standard MAC address
IEC 61850... GSSE/GOOSE...
Range: Enabled, Disabled
Range: 65-character ASCII string
Range: standard MAC address
Range: 0 to 7 in steps of 1
Range: 0 to 4095 in steps of 1
Range: 0 to 16383 in steps of 1
5.2 PRODUCT SETUP
TRANSMISSION GENERAL
TRANSMISSION GSEE
TRANSMISSION FIXED GOOSE
5
5-19