GE DMC490 Software Configuration Manual page 19

Result: The settings pane appears on the right-hand side; for example, Dispatchable Asset1.
5. Configure the Electrical Assets and Thermal Assets Point settings. Refer to the Configure Electrical Assets
section on page 20 for more details.
6. Add digital/analog inputs and digital/analog outputs for the assets.
7. Set the time periods for the forecasts: System (Settings > Economic Dispatch setup.
8. Configure annunciator alarms (Configuration > Alarm tab > Alarm Points tab) that are viewed on the
Active Alarms page.
9. Set the operating mode of the MGC assets (that is, Renewable assets, Dispatchable Assets, and Thermal
CHP Assets
10. Configure forecast settings for optimization.
11. Map the Electrical Assets and Thermal Assets status points to the Datalogger (click: Data Logger
powerbar button) so that you can analyze decisions made by the Optimizer over the logging period.
12. Repeat steps 1 to 11 for each microgrid asset.
System Settings
» To configure microgrid system settings:
1. Click the Configuration Power Bar button and select the MGC tab.
Result: The Electrics pane appears.
2. Select the Settings (System Settings) tab.
3. Select the System Settings group:
•
System Settings
•
Economic Dispatch
•
Command Scheduler
Dispatchable Units
o
Storage Units
o
Result: The settings pane appears on the right-hand side; for example, System Settings.
DMC490 Configuration
19