Table of Contents
Advertisement
C C A A U U T T I I O O N N
It may be wise to keep a separate written record in the log sheet, at the rear of this book, of
which trays are fitted with drives, along with their specification. Update this record with
any changes or additions.
9.
Gently push the drive into the bay. To engage the latch, the carrier handle should be
approximately at a 45 angle from the vertical front of the chassis. As you push the
drive into the bay, the two rounded notches in the carrier handle (B) in illustration
below, slide onto the two round pegs inside the drive bay (A). When they engage,
push the handle straight up (C) to lock the notches onto the pegs and press the
rounded tab on the right of the carrier to the left until it clears the edge of the bay and
snaps into place.
N N O O T T E E
Since the hard disk drives for your Mitsubishi server are exclusively SCSI drives, it is
important to note that the SCSI connector on the backplane of the drive module contains
the device address. This means that, for a given connector, any disk drive that is fitted to
that connector will have the same SCSI address.
10. Close the metal door, and secure it to the chassis with the plastic latch.
11. For security and to prevent unauthorised access to the bays, insert a padlock through
the metal loop protruding through the door.
12. Close the front bezel.
A. Round peg inside drive bay
B. Round notches on carrier handle (must fit over pegs in drive bay)
C. Carrier handle
E x c h a n g i n g S C S I h a r d d r i v e s
B
C
FT5000 HANDBOOK
A
3/3
Advertisement
Table of Contents
