Table of Contents
Advertisement
1
SYSTEM INTRODUCTION
The FT5000 server is designed to either stand upright (pedestal mode) or be mounted in a rack
(rack mode). Figures below show examples of these configurations. Before operation, you must
configure the server for one of the two modes. (As standard the FT5000 is fitted with the pedestal
mountings, but a separate rack mounting kit is available).
If you require a rack mounting kit and have not already purchased one, contact your Mitsubishi
Electric supplier for details. For installation in an equipment rack, see the 'FT5000 Rack
Mounting Guide' booklet for full information.
Server physical specifications
Specification
Height
Width
Depth
Weight
Required front clearance
Required rear clearance
Required side clearance
Typical rack with three servers
Pedestal Mode
48.26 cm (19 inches)
31.12 cm (12.25 inches)
63.5 cm (25 inches)
38.25 kg minimum configuration
45 kg maximum configuration
25 cm (inlet airflow <35 °C / 95 °F)
25 cm (no airflow restriction)
None, but side clearance required for service
OM08045
Rack Mode
7u
19 inch rack
63.5 cm (25 inches)
38.25 kg minimum configuration
45 kg maximum configuration
25 cm (inlet airflow <35 °C / 95 °F)
25 cm (no airflow restriction)
N/A
Single server in pedestal mode
FT5000 HANDBOOK
OM08000
1/1
Advertisement
Table of Contents
