Table of Contents
Advertisement
R a c k m o u n t i n g t h e F T 5 0 0 0
2.
Press the flat side of the outer bar into the U-shaped sections of the brackets.
3.
Slide the assembly toward the front of the rack until the end of the outer bar is flush with the
end of the U-shaped section of the front bracket.
4.
Gently slide the centre bar toward the front of the rack, and position the oblong slot in it over
the first hole in the large outer bar. Insert a screw through the hole in the bar and the first
hole in the front bracket. Place a lock washer and a nut on the screw, and loosely tighten it.
5.
Position the oblong slot in the centre bar over the third hole back from the front of the large
outer bar. Insert a screw through the hole and the oblong slot in the front bracket. Place a lock
washer and nut on the screw, and loosely tighten it.
6.
The back bracket has two holes and three slots in it. This end of the outer bar has four holes
in it. Which holes and slots you use depend on the depth of the equipment rack. After fitting
the bar into the bracket, insert two screws through the holes in the bar and the appropriate
oblong slots in the bracket. Place a lock washer and a nut on each screw, and loosely tighten
them.
7.
Ensure that the brackets and bars are positioned correctly in the rack. Then tighten all screws
firmly.
A/8
FT5000 HANDBOOK
1
2
4
3
2
4
1
Back right-angle extension bracket
2
Screw
3
Flat washer, lock washer and nut
4
Large outer bar
5
Safety latch on centre bar
6
Centre bar
7
Front right-angle extension bracket
2
5
6
7
2
2
6
Advertisement
Table of Contents
