HP 10500 Series Configuration Manual page 38

By configuring OSPFv3 process-to-IPv6 VPN instance bindings on an IPv6 MCE, you allow routes of
different IPv6 VPNs to be exchanged between the IPv6 MCE and the sites through different OSPFv3
processes, ensuring the separation and security of IPv6 VPN routes.
For more information about OSPFv3, see Layer 3—IP Routing Configuration Guide.
To configure OSPFv3 between IPv6 MCE and VPN site:
Step
1. Enter system view.
2. Create an OSPFv3 process for
a VPN instance and enter
OSPFv3 view.
3. Set the router ID.
4. Redistribute remote site routes
advertised by the PE..
5. Return to system view.
6. Enter interface view.
7. Enable OSPFv3 on the
interface.
Configuring IPv6 IS-IS between an IPv6 MCE and a VPN site
An IPv6 IS-IS process belongs to the public network or a single IPv6 VPN instance. If you create an IPv6
IS-IS process without binding it to an IPv6 VPN instance, the process belongs to the public network.
By configuring IPv6 IS-IS process-to-IPv6 VPN instance bindings on an IPv6 MCE, you allow routes of
different IPv6 VPNs to be exchanged between the IPv6 MCE and the sites through different IPv6 IS-IS
processes, ensuring the separation and security of IPv6 VPN routes.
For more information about IPv6 IS-IS, see Layer 3—IP Routing Configuration Guide.
To configure IPv6 IS-IS between IPv6 MCE and VPN site:
Step
1. Enter system view.
2. Create an IPv6 IS-IS process
for a VPN instance and enter
IS-IS view.
3. Configure a network entity
title for the IS-IS process.
4. Enable the IPv6 capacity for
the IPv6 IS-IS process.
Command
system-view
ospfv3 [ process-id ] vpn-instance
vpn-instance-name
router-id router-id
import-route protocol [ process-id
| all-processes | allow-ibgp ] [ cost
cost | route-policy
route-policy-name | type type ] *
quit
interface interface-type
interface-number
ospfv3 process-id area area-id
[ instance instance-id ]
Command
system-view
isis [ process-id ] vpn-instance
vpn-instance-name
network-entity net
ipv6 enable
32
Remarks
N/A
Perform this configuration on the
IPv6 MCE. On the VPN site,
configure normal OSPFv3.
Deleting a VPN instance also
deletes all bound OSPFv3
processes.
N/A
By default, OSPFv3 does not
redistribute routes from any other
routing protocol.
N/A
N/A
By default, OSPFv3 is disabled on
an interface.
Remarks
N/A
Perform this configuration on the
IPv6 MCE. On a VPN site,
configure normal IPv6 IS-IS.
By default, no NET is configured.
By default, IPv6 is disabled.