HP 10500 Series Configuration Manual page 140

Figure 45 Network diagram
MPLS backbone
AS 100
PE 1
CE 1
AS 65001
Device
CE 1
PE 1
ASBR-PE 1
Configuration procedure
Configure IGP on the MPLS backbone to implement the connectivity in the backbone:
1.
This example uses OSPF. (Details not shown.)
After the configurations, each ASBR PE and the PE in the same AS can establish OSPF adjacencies.
Execute the display ospf peer command. The output shows that the adjacencies are in Full state,
and that PEs can learn the routes to the loopback interfaces of each other.
Each ASBR PE and the PE in the same AS can ping each other.
Configure basic MPLS and MPLS LDP on the MPLS backbone to establish LDP LSPs:
2.
# Configure basic MPLS on PE 1, and enable MPLS LDP on the interface connected to ASBR PE 1.
<PE1> system-view
[PE1] mpls lsr-id 1.1.1.9
[PE1] mpls ldp
[PE1-ldp] quit
[PE1] interface vlan-interface 11
[PE1-Vlan-interface11] mpls enable
[PE1-Vlan-interface11] mpls ldp enable
[PE1-Vlan-interface11] quit
# Configure basic MPLS on ASBR PE 1, and enable MPLS LDP on the interface connected to PE 1.
<ASBR-PE1> system-view
[ASBR-PE1] mpls lsr-id 2.2.2.9
Loop0
Vlan-int12
Vlan-int11
ASBR-PE 1
Loop0
Vlan-int11
Vlan-int12
Vlan-int12
Interface IP address
Vlan-int12 10.1.1.1/24
Loop0 1.1.1.9/32
Vlan-int12 10.1.1.2/24
Vlan-int11 172.1.1.2/24
Loop0 2.2.2.9/32
Vlan-int11 172.1.1.1/24
Vlan-int12 192.1.1.1/24
Loop0
Vlan-int12
Vlan-int11
ASBR-PE 2
Vlan-int11
Vlan-int12
Vlan-int12
AS 65002
Device
CE 2
PE 2
ASBR-PE 2
134
MPLS backbone
AS 200
Loop0
PE 2
CE 2
Interface IP address
Vlan-int12 10.2.1.1/24
Loop0 4.4.4.9/32
Vlan-int12 10.2.1.2/24
Vlan-int11 162.1.1.2/24
Loop0 3.3.3.9/32
Vlan-int11 162.1.1.1/24
Vlan-int12 192.1.1.2/24