Configuring Routing Between Pes - HP 10500 Series Configuration Manual

Step
4. Configure the CE as the VPN
IBGP peer.
5. Create and enter BGP VPN
IPv4 unicast family view.
6. Enable IPv4 unicast route
exchange with the specified
peer.
Configure the CE as a client
7.
of the RR.
8. (Optional.) Enable route
reflection between clients.
9. (Optional.) Configure the
cluster ID for the RR.
Configure the CE:
2.
Step
1. Enter system view.
2. Enter BGP view.
3. Configure the PE as an IBGP
peer.
4. Create and enter BGP IPv4
unicast family view.
5. Enable IPv4 unicast route
exchange with the specified
peer or peer group.
6. (Optional.) Configure route
redistribution.

Configuring routing between PEs

Command
peer { group-name | ip-address }
as-number as-number
ipv4-family [ unicast ]
peer { group-name | ip-address }
enable
peer { group-name | ip-address }
reflect-client
reflect between-clients
reflector cluster-id { cluster-id |
ip-address }
Command
system-view
bgp as-number
peer { group-name | ip-address }
as-number as-number
ipv4-family [ unicast ]
peer { group-name | ip-address }
enable
import-route protocol [ { process-id
| all-processes } [ med med-value |
route-policy route-policy-name ] * ]
111
Remarks
By default, no BGP peer is created.
N/A
By default, BGP does not exchange
IPv4 unicast routes with any peer.
By default, no RR or RR client is
configured, and the PE does not
advertise routes learned from the
IBGP peer CE to other IBGP peers,
including VPNv4 IBGP peers. The
PE advertises routes learned from
the CE to other IBGP peers only
when you configure the IBGP peer
CE as a client of the RR.
Configuring an RR does not
change the next hop of a route. To
change the next hop of a route,
configure an inbound policy on the
receiving side.
Route reflection between clients is
enabled by default.
By default, the RR uses its own
router ID as the cluster ID.
If multiple RRs exist in a cluster, use
this command to configure the
same cluster ID for all RRs in the
cluster to avoid routing loops.
Remarks
N/A
N/A
By default, no BGP peer is created.
N/A
By default, BGP does not exchange
IPv4 unicast routes with any peer.
A CE must redistribute its routes to
the PE so the PE can advertise them
to the peer CE.