HP 10500 Series Configuration Manual page 165

Take PE 1 as an example:
[PE1] display mpls ldp peer
Total number of peers: 1
Peer LDP ID
4.4.4.9:0
[PE1] display bgp peer vpnv4
BGP local router ID: 3.3.3.9
Local AS number: 100
Total number of peers: 1
Peer
4.4.4.9
[PE1] display isis peer
System Id: 0000.0000.0005
Interface: Vlan-interface2
State: Up
System Id: 0000.0000.0005
Interface: Vlan-interface2
State: Up
Configure the customer VPN. Use IS-IS as the IGP protocol, and enable LDP between PE 3 and CE
2.
1, and between PE 4 and CE 2:
# Configure PE 3.
<PE3> system-view
[PE3] interface loopback 0
[PE3-LoopBack0] ip address 1.1.1.9 32
[PE3-LoopBack0] quit
[PE3] mpls lsr-id 1.1.1.9
[PE3] mpls ldp
[PE3-ldp] quit
[PE3] isis 2
[PE3-isis-2] network-entity 10.0000.0000.0000.0001.00
[PE3-isis-2] quit
[PE3] interface loopback 0
[PE3-LoopBack0] isis enable 2
[PE3-LoopBack0] quit
[PE3-Vlan-interface2] ip address 10.1.1.1 24
[PE3-Vlan-interface2] isis enable 2
[PE3-Vlan-interface2] mpls enable
[PE3-Vlan-interface2] mpls ldp enable
[PE3-Vlan-interface2] quit
# Configure CE 1.
<CE1> system-view
State LAM
Operational DU
AS MsgRcvd
100
Peer information for ISIS(1)
----------------------------
HoldTime: 8s
HoldTime: 8s
159
Role GR MD5
Active Off Off
Peers in established state: 1
MsgSent OutQ PrefRcv Up/Down
3 6 0
Circuit Id: 0000.0000.0005.02
Type: L1(L1L2)
Circuit Id: 0000.0000.0005.02
Type: L2(L1L2)
KA Sent/Rcvd
8/8
State
0 00:00:32 Established
PRI: 64
PRI: 64