Ipv6 Mpls L3Vpn Network Schemes And Functions; Ipv6 Mpls L3Vpn Configuration Task List; Configuring Basic Ipv6 Mpls L3Vpn - HP 10500 Series Configuration Manual

The PEs use an IGP to ensure the connectivity between them.
From the egress PE to the remote peer CE:
3.
The egress PE compares the export target attributes of the VPN-IPv6 routes with the import target
attributes that it maintains for the VPN instance and, if they are the same, adds the routes to the
routing table of the VPN instance. The egress PE restores the original IPv6 routes and advertises
them to the remote CE through IPv6 static routing, RIPng, OSPFv3, IPv6 IS-IS, or EBGP.

IPv6 MPLS L3VPN network schemes and functions

IPv6 MPLS L3VPN supports the following network schemes and functions:
Basic VPN
•
Inter-AS VPN option A
•
Inter-AS VPN option C
•

IPv6 MPLS L3VPN configuration task list

By configuring basic IPv6 MPLS L3VPN, you can construct a simple IPv6 VPN network over an MPLS
backbone.
To deploy special IPv6 MPLS L3VPN networks, such as inter-AS VPN, you must also perform specific
configurations in addition to the basic IPv6 MPLS L3VPN configuration. For details, see the related
sections.
Tasks at a glance

Configuring basic IPv6 MPLS L3VPN

Configuring inter-AS IPv6 VPN
Configuring basic IPv6 MPLS L3VPN
The key task in IPv6 MPLS L3VPN configuration is to manage the advertisement of IPv6 VPN routes on the
MPLS backbone, including management of PE-CE route exchange and PE-PE route exchange.
To configure basic IPv6 MPLS L3VPN:
Tasks at a glance
Configuring VPN
1. (Required.)
2. (Required.)
3. (Optional.)
(Required.)
instances:
Creating a VPN instance
Associating a VPN instance with an interface
Configuring route related attributes for a VPN instance
Configuring routing between a PE and a CE
181